![]() Please help me if you have any ideas about what blocking localhost:80. Output of sudo iptables -t mangle -nL Chain PREROUTING (policy ACCEPT) I didn't get any output of sudo iptables -t mangle -nVL, only version: iptables v1.4.21 Output of $ sudo iptables -t nat -nvL: Chain PREROUTING (policy ACCEPT 1 packets, 40 bytes) Using auto-install script If it's for Ubuntu like Linux, you can run the auto-install script from our website with the following command. TX packets:276 errors:0 dropped:0 overruns:0 carrier:0 When you don't have 127.0.0.1 set on your system, NxFilter will not be working properly. RX packets:276 errors:0 dropped:0 overruns:0 frame:0 it will then use its local Unbound (127.0.0.1:5335) which will then do recursive lookup. TX packets:616 errors:0 dropped:0 overruns:0 carrier:0 The NxFilter DNS appliance rounds out the list. RX packets:588 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 Loopback interface is up: $ ifconfig eth0 Link encap:Ethernet HWaddr 08:00:27:86:5f:e3 Nmap done: 1 IP address (1 host up) scanned in 1.12 seconds ![]() I tried $ sudo nmap -sS 127.0.0.1 -p 80 and got info - 80/tcp closed, but how it's possible if running nginx server on port 80? Nmap scan report for localhost (127.0.0.1) And also I can connect with my subnet ip-address 10.0.2.15.Īnd If I change port 80 to another in server config (e.g. It's interesting that I can connect to any address 127.* except 127.0.0.1 (localhost). Iptables disabled $ sudo iptables -L: Chain INPUT (policy ACCEPT) # The following lines are desirable for IPv6 capable hosts Telnet: Unable to connect to remote host: Connection refusedĪll right in /etc/hosts: 127.0.1.1 ubuntu-work * Failed to connect to 127.0.0.1 port 80: Connection refusedĬurl: (7) Failed to connect to 127.0.0.1 port 80: Connection refused * connect to 127.0.0.1 port 80 failed: Connection refused for ages so after some research, i found the reset-pw. $ curl -v 127.0.0.1 * Rebuilt URL to: 127.0.0.1/ 1 wrong password 10-12-2021, 04:12 PM Hello all, running nxfilter on a RasPi after the holidays i want to re-enable the filter but my password seems to be wrong which is bizar, because i'm using KeePass to remember it. I have running nginx server (doesn't matter which server): Jun 27, 2019, 9:57:18 AM to NxFilter So after previously running PiHole on Ubuntu server 16.04 as the DNS server for my home network, I felt like i'd give NxFilter a go, the problem is, I just.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |